Avidemux Copy Mode vs Re-encoding: What “Copy” Actually Means

Copy mode in Avidemux means the video (or audio) stream is copied bit-for-bit from the input file to the output file without being decoded or re-encoded. Nothing about the picture or sound data changes: no quality is lost, and the job finishes in seconds rather than minutes. The trade-off: because the compressed data is passed through untouched, you can only cut on keyframes, you cannot use any filters, and the output container must accept the source codecs as-is.

Re-encoding is the opposite: Avidemux decodes every frame to raw pixels, applies your edits and filters, then compresses everything again with the encoder you chose (e.g. x264). It is slower and loses a little quality, but it allows frame-accurate cuts, filters, and any valid codec/container combination.

This distinction — Copy vs re-encode — is the single most important concept in Avidemux. Nearly every confusing behavior beginners hit (greyed-out filters, save errors, “too short” warnings) traces back to it.

Copy vs re-encode at a glance

Copy mode Re-encoding
What happens Stream copied untouched Decoded, processed, compressed again
Speed Seconds (disk speed) Minutes (CPU/GPU speed)
Quality Lossless — bit-identical Small generation loss (tunable)
Cut precision Keyframes only Any frame
Filters Not available (disabled) Fully available
Container freedom Container must accept source codecs Any valid combination

Decision guide: which tasks allow Copy?

Task Mode Notes
Cut / trim a video Copy Cut on keyframes; see lossless cutting
Split into parts Copy Keyframe rules apply; see splitting guide
Join / append clips Copy Clips must match parameters; see merging guide
Remove an audio track Copy (video) See remove audio
Extract audio to MP3 N/A (audio only) See extract audio
Rotate / resize / filters / subtitles burn-in Re-encode Pixel changes require an encoder
Change volume / normalize audio Re-encode audio (video can stay Copy) See volume guide
Compress / shrink file size Re-encode See compress video
Convert container (e.g. MKV → MP4), same codecs Copy Remuxing; container must support the codecs

The hybrid: Copy video + re-encode audio

The two dropdowns — Video Output and Audio Output — are independent. The most useful hybrid: Video Output = Copy with Audio Output = an encoder (AAC/MP3). You get lossless, instant video plus processed audio — exactly what the volume/normalize workflow and the audio-shift sync fix use. This combination is why Avidemux exposes the two settings separately.

Why so many errors trace back to this setting

  • Filters greyed out? Video Output is on Copy — filters need an encoder. (Fix)
  • “Muxer: Cannot open”? Copy mode asked the container to accept codecs it cannot hold. (Fix)
  • “Too short” after saving? Copy-mode cuts on non-keyframes broke the timestamps. (Fix)
  • Append failing? Copy mode demands matching parameters across clips. (Fix)

When something in Avidemux behaves unexpectedly, check the Video/Audio Output dropdowns first — nine times out of ten, the answer is there.

Frequently asked questions

What is Copy mode in Avidemux?

Copy mode copies the video or audio stream bit-for-bit from input to output without decoding or re-encoding it. It is lossless and very fast, but limited to keyframe cuts, no filters, and containers that accept the source codecs.

Does Copy mode lose quality?

No — the compressed data is passed through untouched, so the output is bit-identical to the input for that stream. Quality loss only occurs when re-encoding.

Why are my filters greyed out?

Because Video Output (or Audio Output, for audio filters) is set to Copy. Filters modify the data, which requires decoding and re-encoding — select a real encoder to unlock them.

Can I use Copy for video but re-encode the audio?

Yes — the Video Output and Audio Output settings are independent. Video = Copy plus Audio = AAC/MP3 is a common and fully supported combination.